Service-Induced Damages of the Ceramic Thrust Bearing Pivot in the Seal Section of Electrical Centrifugal Pump System
- Autores: Kuzin V.V.1, Fedorov S.Y.1, Reutov V.L.1, Koshcheev V.V.2
-
Afiliações:
- Federal State Budgetary Educational Institution of Higher Education “Moscow State Technological University “Stankin”
- Limited Liability Company “PK “Remelektropromneft”
- Edição: Volume 59, Nº 5 (2019)
- Páginas: 564-568
- Seção: Article
- URL: https://journals.rcsi.science/1083-4877/article/view/249160
- DOI: https://doi.org/10.1007/s11148-019-00273-6
- ID: 249160
Citar
Resumo
The paper provides the results of studying the condition of the working pivot of thrust bearings made of reaction- sintered silicon carbide-based ceramics (SiSiC-ceramics) removed from the seal section of the electrical centrifugal pump system. The working surface of the pivot demonstrates numerous service-induced damages of different origin resulting from friction. Based on categorization of these damages, recommendations were made concerning the improvement of the ceramic thrust bearing design.
Sobre autores
V. Kuzin
Federal State Budgetary Educational Institution of Higher Education “Moscow State Technological University “Stankin”
Autor responsável pela correspondência
Email: kyzena@post.ru
Rússia, Moscow
S. Fedorov
Federal State Budgetary Educational Institution of Higher Education “Moscow State Technological University “Stankin”
Email: kyzena@post.ru
Rússia, Moscow
V. Reutov
Federal State Budgetary Educational Institution of Higher Education “Moscow State Technological University “Stankin”
Email: kyzena@post.ru
Rússia, Moscow
V. Koshcheev
Limited Liability Company “PK “Remelektropromneft”
Email: kyzena@post.ru
Rússia, Lysva
Arquivos suplementares
