Enviar artigo por via de e-mail Mechanical Properties of Products after Electric-Discharge Machining
- Autores: Ablyaz T.R.1, Vil’deman V.E.1, Muratov K.R.1, Il’inykh A.V.1
-
Afiliações:
- Perm National Research Polytechnic University
- Edição: Volume 39, Nº 10 (2019)
- Páginas: 892-894
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227868
- DOI: https://doi.org/10.3103/S1068798X19100046
- ID: 227868
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
The mechanical properties of 38Х2Н2МА steel components after electric-discharge machining (EDM) are experimentally studied. The strength of workpieces obtained by turning and EDM is compared. The life of samples in few-cycle fatigue is determined. The life of 38Х2Н2МА steel samples after EDM is 30% less than after turning. There is little difference in the strength of 38Х2Н2МА steel samples after EDM and after turning.
Palavras-chave
Sobre autores
T. Ablyaz
Perm National Research Polytechnic University
Autor responsável pela correspondência
Email: lowrider11-13-11@mail.ru
Rússia, Perm
V. Vil’deman
Perm National Research Polytechnic University
Email: karimur_80@mail.ru
Rússia, Perm
K. Muratov
Perm National Research Polytechnic University
Autor responsável pela correspondência
Email: karimur_80@mail.ru
Rússia, Perm
A. Il’inykh
Perm National Research Polytechnic University
Email: karimur_80@mail.ru
Rússia, Perm
Arquivos suplementares
