Enviar artigo por via de e-mail Influence of cut layer on cutting
- Autores: Kabaldin Y.G.1, Kuz’mishina A.A.1, Zotov V.O.1, Vlasov E.E.1
-
Afiliações:
- Alekseev Nizhny Novgorod State Technical University
- Edição: Volume 37, Nº 11 (2017)
- Páginas: 962-968
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227178
- DOI: https://doi.org/10.3103/S1068798X17110053
- ID: 227178
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
The contact of the chip with the tool’s front surface in cutting is analyzed by numerical modeling. The high-pressure zones and buildup at the tool’s contact surface are studied. The influence of plastic instability of the chip surface and vortex deformation modes on tool wear is considered.
Palavras-chave
Sobre autores
Yu. Kabaldin
Alekseev Nizhny Novgorod State Technical University
Autor responsável pela correspondência
Email: uru.40@mail.ru
Rússia, Nizhny Novgorod
A. Kuz’mishina
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Rússia, Nizhny Novgorod
V. Zotov
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Rússia, Nizhny Novgorod
E. Vlasov
Alekseev Nizhny Novgorod State Technical University
Email: uru.40@mail.ru
Rússia, Nizhny Novgorod
Arquivos suplementares
