Email this article Basing Errors in Machining and Monitoring
- Authors: Sheinin G.M.1, Bobkov M.N.1, Bochkova D.E.1
-
Affiliations:
- Tula State University
- Issue: Vol 39, No 6 (2019)
- Pages: 523-529
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227737
- DOI: https://doi.org/10.3103/S1068798X19060169
- ID: 227737
Cite item
Open Access
Access granted
Subscription Access
Abstract
This research is focused on sketch bases in machining and monitoring and on basing errors in machining and monitoring. In other words, attention is directed to machining or monitoring errors produced by oscillations in the position of sketch bases relative to the machined surfaces of the components. The use of sketch bases in combination with technological and measurement bases is recommended.
Keywords
About the authors
G. M. Sheinin
Tula State University
Email: bochkovade@rambler.ru
Russian Federation, Tula
M. N. Bobkov
Tula State University
Author for correspondence.
Email: bobkov-mixail@inbox.ru
Russian Federation, Tula
D. E. Bochkova
Tula State University
Author for correspondence.
Email: bochkovade@rambler.ru
Russian Federation, Tula
Supplementary files
