Enviar artigo por via de e-mail Basing Errors in Machining and Monitoring
- Autores: Sheinin G.M.1, Bobkov M.N.1, Bochkova D.E.1
-
Afiliações:
- Tula State University
- Edição: Volume 39, Nº 6 (2019)
- Páginas: 523-529
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227737
- DOI: https://doi.org/10.3103/S1068798X19060169
- ID: 227737
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
This research is focused on sketch bases in machining and monitoring and on basing errors in machining and monitoring. In other words, attention is directed to machining or monitoring errors produced by oscillations in the position of sketch bases relative to the machined surfaces of the components. The use of sketch bases in combination with technological and measurement bases is recommended.
Palavras-chave
Sobre autores
G. Sheinin
Tula State University
Email: bochkovade@rambler.ru
Rússia, Tula
M. Bobkov
Tula State University
Autor responsável pela correspondência
Email: bobkov-mixail@inbox.ru
Rússia, Tula
D. Bochkova
Tula State University
Autor responsável pela correspondência
Email: bochkovade@rambler.ru
Rússia, Tula
Arquivos suplementares
