Email this article Improving Cutter Performance in Turning Complex Profiles
- Authors: Kudryashov E.A.1, Smirnov I.M.1, Stepanov Y.S.2, Khizhnyak N.A.1
-
Affiliations:
- AO Scientific-Research Engineering Institute
- Education–Science–Production Complex (State University)
- Issue: Vol 38, No 12 (2018)
- Pages: 1003-1008
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227592
- DOI: https://doi.org/10.3103/S1068798X18120122
- ID: 227592
Cite item
Open Access
Access granted
Subscription Access
Abstract
Abstract—Recommendations for expanding the applicability of tool materials in the discontinuous turning of complex parts and heterogeneous subassemblies are developed on the basis of the requirements on three modules that constitute the cutting tool: the tool module, the adjustment module, and the damping module.
About the authors
E. A. Kudryashov
AO Scientific-Research Engineering Institute
Author for correspondence.
Email: kea-swsu@mail.ru
Russian Federation, Balashikha
I. M. Smirnov
AO Scientific-Research Engineering Institute
Email: kea-swsu@mail.ru
Russian Federation, Balashikha
Yu. S. Stepanov
Education–Science–Production Complex (State University)
Email: kea-swsu@mail.ru
Russian Federation, Orel
N. A. Khizhnyak
AO Scientific-Research Engineering Institute
Email: kea-swsu@mail.ru
Russian Federation, Balashikha
Supplementary files
