Email this article Optimization of the High-Speed Turning of High-Temperature Nickel Alloy
- Authors: Albagachiev A.Y.1,2, Krasko A.S.1, Stramtsova E.S.1
-
Affiliations:
- Moscow State Institute of Radioengineering, Electronics, and Automation
- Institute of Mechanical Engineering, Russian Academy of Sciences
- Issue: Vol 38, No 10 (2018)
- Pages: 776-779
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227544
- DOI: https://doi.org/10.3103/S1068798X18100040
- ID: 227544
Cite item
Open Access
Access granted
Subscription Access
Abstract
Existing recommendations regarding the high-speed milling of metals are considered. To optimize the cutting temperature, an inverse method of determining the best cutting speed in the turning of KhN77TYu high-temperature nickel alloy is proposed. MathCAD software is used to calculate the machining conditions.
About the authors
A. Yu. Albagachiev
Moscow State Institute of Radioengineering, Electronics, and Automation; Institute of Mechanical Engineering, Russian Academy of Sciences
Author for correspondence.
Email: albagachiev@yandex.ru
Russian Federation, Moscow; Moscow
A. S. Krasko
Moscow State Institute of Radioengineering, Electronics, and Automation
Email: albagachiev@yandex.ru
Russian Federation, Moscow
E. S. Stramtsova
Moscow State Institute of Radioengineering, Electronics, and Automation
Email: albagachiev@yandex.ru
Russian Federation, Moscow
Supplementary files
