Email this article Improvement of Hole Drilling in High-Strength Polymer Laminate
- Authors: Maslov A.R.1, Mamot’ko A.I.1
-
Affiliations:
- Stankin Moscow State Technical University
- Issue: Vol 38, No 7 (2018)
- Pages: 517-518
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227480
- DOI: https://doi.org/10.3103/S1068798X18070134
- ID: 227480
Cite item
Open Access
Access granted
Subscription Access
Abstract
When the end section of helicopter screw blades made of polymer laminate based on glass–carbon fiber and reinforced by titanium foil is drilled, peeling is noted at the entrance to the hole. Such peeling is investigated in the present work. The influence of the cutting speed and supply on the extent of the peeling is established.
About the authors
A. R. Maslov
Stankin Moscow State Technical University
Author for correspondence.
Email: vestnik@stankin.ru
Russian Federation, Moscow
A. I. Mamot’ko
Stankin Moscow State Technical University
Email: vestnik@stankin.ru
Russian Federation, Moscow
Supplementary files
