Email this article Hole shaping in the honing of thin-walled cylinders
- Authors: Ogorodov V.A.1
-
Affiliations:
- Ufa State University of Petroleum Technology
- Issue: Vol 37, No 6 (2017)
- Pages: 549-553
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227328
- DOI: https://doi.org/10.3103/S1068798X17060168
- ID: 227328
Cite item
Open Access
Access granted
Subscription Access
Abstract
The possibility of obtaining specified hole geometry in a thin-walled cylinder by honing is studied. One promising option is the deliberate deformation of the workpiece when it is attached by means of disk springs.
About the authors
V. A. Ogorodov
Ufa State University of Petroleum Technology
Author for correspondence.
Email: sempersnovi@yandex.ru
Russian Federation, Ufa
Supplementary files
