Factors affecting the angular velocity of the workpiece in abrasive finishing
- Autores: Muratov K.R.1, Gashev E.A.1, Lagunov D.M.1
-
Afiliações:
- Perm National Research Polytechnic University
- Edição: Volume 37, Nº 2 (2017)
- Páginas: 167-170
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227243
- DOI: https://doi.org/10.3103/S1068798X17020137
- ID: 227243
Citar
Resumo
The influence of the abrasive-finishing parameters on the angular velocity of the part over the surface of the tool is investigated for lapping machines with a raster tool trajectory, where the frictional interaction between the lap and the part is utilized. It is established that the factors with the greatest effect on the angle and angular velocity in lapping are the force holding the lap against the part, the grain size of the abrasive, and the lapping method.
Palavras-chave
Sobre autores
K. Muratov
Perm National Research Polytechnic University
Autor responsável pela correspondência
Email: Karimur_80@mail.ru
Rússia, Perm
E. Gashev
Perm National Research Polytechnic University
Email: Karimur_80@mail.ru
Rússia, Perm
D. Lagunov
Perm National Research Polytechnic University
Email: Karimur_80@mail.ru
Rússia, Perm
Arquivos suplementares
