Enviar artigo por via de e-mail Single-turn worm mills for conical round-tooth gears
- Autores: Kondrashov A.G.1, Safarov D.T.1, Faskhutdinov A.I.1, Davletshina G.K.1
-
Afiliações:
- Naberezhnye Chelny Institute
- Edição: Volume 37, Nº 9 (2017)
- Páginas: 812-813
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227146
- DOI: https://doi.org/10.3103/S1068798X17090143
- ID: 227146
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
Facets must be machined at the end of gear teeth. The shaping of facets by single-turn worm mills is considered in detail. Deficiencies are found in familiar design methods for such mills. Formulas are proposed for the calculation of single-turn worm mills used in machining conical round-tooth gears.
Palavras-chave
Sobre autores
A. Kondrashov
Naberezhnye Chelny Institute
Autor responsável pela correspondência
Email: kondrashovag@mail.ru
Rússia, Naberezhnye Chelny
D. Safarov
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Rússia, Naberezhnye Chelny
A. Faskhutdinov
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Rússia, Naberezhnye Chelny
G. Davletshina
Naberezhnye Chelny Institute
Email: kondrashovag@mail.ru
Rússia, Naberezhnye Chelny
Arquivos suplementares
