Email this article Influence of the wire EDM conditions on the cut width
- Authors: Ablyaz T.R.1, Lesnikov R.V.1
-
Affiliations:
- Perm National Research Polytechnic University
- Issue: Vol 36, No 9 (2016)
- Pages: 786-787
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227029
- DOI: https://doi.org/10.3103/S1068798X16090033
- ID: 227029
Cite item
Open Access
Access granted
Subscription Access
Abstract
The influence of the conditions of wire electric-discharge machining (EDM) on the cut width in the machining of 09G2S steel is experimentally investigated. The relation between the cutting power and the cut width is obtained. It is shown that, with reduction in the power, more thermal energy is concentrated at the machined section of surface, the probability of secondary spark discharges increases, and consequently the cut width increases.
About the authors
T. R. Ablyaz
Perm National Research Polytechnic University
Author for correspondence.
Email: lowrider11-13-11@mail.ru
Russian Federation, Perm, 614990
R. V. Lesnikov
Perm National Research Polytechnic University
Email: lowrider11-13-11@mail.ru
Russian Federation, Perm, 614990
Supplementary files
