Email this article Shaping of Heat-Exchanger Pins by Deformational Cutting
- Authors: Zubkov N.N.1, Bityutskaya Y.L.1, Voinov S.A.1
-
Affiliations:
- Bauman Moscow State Technical University
- Issue: Vol 36, No 2 (2016)
- Pages: 81-85
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/226013
- DOI: https://doi.org/10.3103/S1068798X16020258
- ID: 226013
Cite item
Open Access
Access granted
Subscription Access
Abstract
The use of a metal plate to simulate pin shaping by deformational cutting is proposed. The influence of the tool geometry on the volume of material removed to form a single pin is considered. Analytical formulas for the cutting angle and the pin length are derived. Experimental data regarding the influence of the cutting parameters on the shape and alignment of the pins are presented
Keywords
About the authors
N. N. Zubkov
Bauman Moscow State Technical University
Author for correspondence.
Email: zoubkovn@bmstu.ru
Russian Federation, Moscow
Yu. L. Bityutskaya
Bauman Moscow State Technical University
Email: zoubkovn@bmstu.ru
Russian Federation, Moscow
S. A. Voinov
Bauman Moscow State Technical University
Email: zoubkovn@bmstu.ru
Russian Federation, Moscow
Supplementary files
