Enviar artigo por via de e-mail Prediction of the cooling of cutting zones by means of vortex tubes in high-speed machining
- Autores: Korkodinov Y.A.1, Peshcherenko S.N.1, Esov V.B.2, Ablyaz T.R.1, Muratov K.R.1
-
Afiliações:
- Perm National Research Polytechnic University
- Bauman Moscow State Technical University
- Edição: Volume 36, Nº 1 (2016)
- Páginas: 71-73
- Seção: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/225985
- DOI: https://doi.org/10.3103/S1068798X16010123
- ID: 225985
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
The possibility of using vortex tubes to inject cooled ionized air into the cutting zone in high-speed machining is considered. Numerical calculation of the vortex effect is employed to predict the cooling of the cutting zone. The results are compared with experimental data.
Palavras-chave
Sobre autores
Ya. Korkodinov
Perm National Research Polytechnic University
Autor responsável pela correspondência
Email: svarogjk1989@rambler.ru
Rússia, Perm
S. Peshcherenko
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Rússia, Perm
V. Esov
Bauman Moscow State Technical University
Email: svarogjk1989@rambler.ru
Rússia, Moscow
T. Ablyaz
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Rússia, Perm
K. Muratov
Perm National Research Polytechnic University
Email: svarogjk1989@rambler.ru
Rússia, Perm
Arquivos suplementares
