Influence of electrospark discharge parameters on roughness and microabrasive wear of steel 45 surface after ESA by TiC-based electrodes


如何引用文章

全文:

开放存取 开放存取
受限制的访问 ##reader.subscriptionAccessGranted##
受限制的访问 订阅存取

详细

The influence of the parameters of electrospark discharge and electrode materials for electrospark alloying using the additives of boron-containing mineral raw material on the characteristics of microgeometry and microabrasive wear of the coating surface is investigated. It is found that the longer is the electrospark duration (from 20 to 80 μs), the higher is the surface roughness. The introduction of 1–2% of boron-containing raw material improves physicochemical properties of the alloyed layer, reduces the roughness, and increases the wear resistance.

作者简介

S. Nikolenko

Institute of Materials Science

编辑信件的主要联系方式.
Email: nikola960@mail.ru
俄罗斯联邦, ul. Tikhookeanskaya 153, Khabarovsk, 680042

A. Verkhoturov

Institute of Water and Ecological Problems

Email: nikola960@mail.ru
俄罗斯联邦, ul. Kim-Yu-Chena 65, Khabarovsk, 680000

N. Syui

Institute of Materials Science

Email: nikola960@mail.ru
俄罗斯联邦, ul. Tikhookeanskaya 153, Khabarovsk, 680042

E. Kuz’michev

Far Eastern State Transport University

Email: nikola960@mail.ru
俄罗斯联邦, ul. Serysheva 47, Khabarovsk, 680021

补充文件

附件文件
动作
1. JATS XML

版权所有 © Allerton Press, Inc., 2016