Overcurrent Protection from Earth Faults Based on Higher Harmonics for Compensated 6- to 10-kV Cable Networks

Аннотация

Devices based on the method of absolute measurement of the level of higher harmonics in zerosequence currents of connections of a protected object are the most commonly used for protection from earth faults in compensated 6- to 10-kV cable networks of industrial and urban power-supply systems. However, many years of operating experience have shown that the technical refinement (the selectivity and the sensitivity) of overcurrent protection from earth faults based on the method of absolute measurement of higher harmonics is not always sufficient. One of the reasons for the low technical refinement of these protection devices is the inaccuracy in estimating the maximum and minimum possible higher harmonics levels in the earth-fault current of compensated 6- to 10-kV cable networks, which are required for the selection of the operating current settings and the sensitivity determination. The main factors influencing the maximum and minimum higher harmonics levels in the earth-fault current and their ratio were revealed on the basis of the computational experiments using the imitation models for 6- to 10-kV cable networks, the limiting values of these levels were determined, an determination of the harmonics-level instability in the fault current for cable networks with different total load compositions was given, and its interrelation with the fluctuations of the total coefficient of harmonic voltage components on 6- to 10-kV buses of network power centers was established. The conditions of applicability and the area of application of overcurrent protection from this type of failure based on the use of higher harmonics of the zero-sequence current for different objects of 6- to 10-kV compensated cable networks were determined taking into account the above estimates. Specifications for a method for selecting the operating current settings were proposed.