Email this article Analysis of the Strength Characteristics of Acrylonitrile–Butadiene–Styrene Plastic under Dynamic Loading
- Authors: Chevrychkina A.A.1,2, Evstifeev A.D.1, Volkov G.A.1,2
-
Affiliations:
- Institute of Problems of Mechanical Engineering
- St. Petersburg State University
- Issue: Vol 63, No 3 (2018)
- Pages: 381-384
- Section: Solid State
- URL: https://journals.rcsi.science/1063-7842/article/view/200952
- DOI: https://doi.org/10.1134/S1063784218030064
- ID: 200952
Cite item
Open Access
Access granted
Subscription Access
Abstract
The mechanical properties of the additive material prepared from acrylonitrile–butadiene–styrene plastic are studied experimentally on a 3D printer in the quasi-static and dynamic regimes. The strength curve describing the nonlinear dependence of the critical stress on the strain rate is constructed using the incubation time. The characteristic incubation time τ is determined by comparing the theoretical curve with the experimental data.
About the authors
A. A. Chevrychkina
Institute of Problems of Mechanical Engineering; St. Petersburg State University
Author for correspondence.
Email: anastasiia.che@gmail.com
Russian Federation, St. Petersburg, 199178; St. Petersburg, 199034
A. D. Evstifeev
Institute of Problems of Mechanical Engineering
Email: anastasiia.che@gmail.com
Russian Federation, St. Petersburg, 199178
G. A. Volkov
Institute of Problems of Mechanical Engineering; St. Petersburg State University
Email: anastasiia.che@gmail.com
Russian Federation, St. Petersburg, 199178; St. Petersburg, 199034
