Email this article Optimization of multi-tip-shaped field emitters with bilayer protective coatings
- Authors: Sominskii G.G.1, Taradaev E.P.1
-
Affiliations:
- Peter the Great St. Petersburg Polytechnic University
- Issue: Vol 62, No 6 (2017)
- Pages: 948-952
- Section: Physical Electronics
- URL: https://journals.rcsi.science/1063-7842/article/view/199568
- DOI: https://doi.org/10.1134/S1063784217060238
- ID: 199568
Cite item
Open Access
Access granted
Subscription Access
Abstract
The calculations needed to optimize the ordered multi-tip-shaped silicon field emitters with the two-layer protective metal-fullerene coatings intended for use in high voltage electronic devices operating in technical vacuum have been performed. The calculations are fulfilled using the COMSOL program. The influence of the morphology of the surface on the emission characteristics of the emitters is determined, including the needles height and radius of their vertices, and also the distance between needles. It has been shown that the emitters with an area of 0.2 cm2, operating under the conditions of partial mutual screening, can provide currents of several hundred milliamps for fairly high voltages.
About the authors
G. G. Sominskii
Peter the Great St. Petersburg Polytechnic University
Author for correspondence.
Email: sominski@rphf.spbstu.ru
Russian Federation, St. Petersburg, 195251
E. P. Taradaev
Peter the Great St. Petersburg Polytechnic University
Email: sominski@rphf.spbstu.ru
Russian Federation, St. Petersburg, 195251
Supplementary files
