Email this article SHS of Y2Ti2O7-based mineral-like ceramics: Influence of green density
- Authors: Barinova T.V.1, Borovinskaya I.P.1, Barinov V.Y.1, Kovalev I.D.1, Podbolotov K.B.2
-
Affiliations:
- Institute of Structural Macrokinetics and Materials Science (ISMAN)
- Belarussian State Technological University
- Issue: Vol 26, No 2 (2017)
- Pages: 119-123
- Section: Article
- URL: https://journals.rcsi.science/1061-3862/article/view/195839
- DOI: https://doi.org/10.3103/S1061386217020030
- ID: 195839
Cite item
Open Access
Access granted
Subscription Access
Abstract
Explored was the influence of compacting pressure (P) and green density (ρ) on the properties of Zr-doped mineral-like pyrochlore ceramics Y2(Ti1 – xZrx)2O7 (x ≤ 0.3) prepared by SHS method. The optimal ρ values that provide minimal porosity and maximal mechanical strength of synthesized ceramics were found. An increase in ρ was found to decrease combustion temperature and increase pyrochlore lattice parameter a. Green density was also found to affect phase composition of the SHS-produced ceramics under study.
Keywords
About the authors
T. V. Barinova
Institute of Structural Macrokinetics and Materials Science (ISMAN)
Author for correspondence.
Email: tbarinova@ism.ac.ru
Russian Federation, Chernogolovka, Moscow, 142432
I. P. Borovinskaya
Institute of Structural Macrokinetics and Materials Science (ISMAN)
Email: tbarinova@ism.ac.ru
Russian Federation, Chernogolovka, Moscow, 142432
V. Yu. Barinov
Institute of Structural Macrokinetics and Materials Science (ISMAN)
Email: tbarinova@ism.ac.ru
Russian Federation, Chernogolovka, Moscow, 142432
I. D. Kovalev
Institute of Structural Macrokinetics and Materials Science (ISMAN)
Email: tbarinova@ism.ac.ru
Russian Federation, Chernogolovka, Moscow, 142432
K. B. Podbolotov
Belarussian State Technological University
Email: tbarinova@ism.ac.ru
Belarus, Minsk
Supplementary files
