Enviar artigo por via de e-mail Improvement of the Fatigue Life of Stainless Steel Specimens by Laser Shock Processing
- Autores: Sakhvadze G.Z.1, Kavtaradze R.Z.2, Nikabadze M.U.3, Kikvidze O.G.4
-
Afiliações:
- Blagonravov Mechanical Engineering Research Institute of the Russian Academy of Sciences (IMASH RAN)
- Bauman Moscow State Technical University
- Lomonosov Moscow State University
- Tsereteli State University
- Edição: Volume 48, Nº 4 (2019)
- Páginas: 353-360
- Seção: New Technologies in Mechanical Engineering
- URL: https://journals.rcsi.science/1052-6188/article/view/194293
- DOI: https://doi.org/10.3103/S1052618819040137
- ID: 194293
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
An investigation concerning the influence of laser shock processing (LSP) of stainless steel specimens made of 03Kh22N6M2 steel for the fatigue life by finite element modeling was performed. The known experimental fatigue life parameters were compared with the data taken from the finite element modeling. A conforming comparison is observed between the numerical and experimental data. It was shown that the thickness of the specimen is an important parameter during application of the LSP technology. It was found that with the decrease in the specimen thickness the fatigue life, conditioned by the LSP application, improves significantly. It was shown that for thin specimens (about 2 mm) the application of the LSP technology improves the fatigue life to 300%.
Palavras-chave
Sobre autores
G. Sakhvadze
Blagonravov Mechanical Engineering Research Institute of the Russian Academy of Sciences (IMASH RAN)
Autor responsável pela correspondência
Email: sakhvadze@mail.ru
Rússia, Moscow, 101990
R. Kavtaradze
Bauman Moscow State Technical University
Email: sakhvadze@mail.ru
Rússia, Moscow, 105005
M. Nikabadze
Lomonosov Moscow State University
Email: sakhvadze@mail.ru
Rússia, Moscow, 119991
O. Kikvidze
Tsereteli State University
Email: sakhvadze@mail.ru
Geórgia, Kutaisi, 4600
Arquivos suplementares
