Development of the Design Model of a Hydrodynamic Lubricating Material Formed during Melting of the Axial Bearing, in the Presence of Forced Lubrication


Citar

Texto integral

Acesso aberto Acesso aberto
Acesso é fechado Acesso está concedido
Acesso é fechado Somente assinantes

Resumo

This work presents a method of formation of an accurate self-similar solution of the problem of hydrodynamic calculation of a wedge-shaped support (slide block, guide) operating in the presence of a lubricating material and melt of the guide. Based on the equation of motion of an viscous incompressible liquid for a “thin layer” and the expression for the energy dissipation rate, an analytical dependence is obtained for the profile of the melted surface of the guide. In addition, the main performance characteristics of the friction couple considered are defined. The influence of the parameter specified by the melt of the guide on the bearing capacity and friction force is estimated.

Sobre autores

M. Mukutadze

Rostov State Transport University

Email: vvv_voen@rgups.ru
Rússia, Rostov-on-Don

E. Lagunova

Rostov State Transport University

Email: vvv_voen@rgups.ru
Rússia, Rostov-on-Don

V. Vasilenko

Rostov State Transport University

Autor responsável pela correspondência
Email: vvv_voen@rgups.ru
Rússia, Rostov-on-Don

Arquivos suplementares

Arquivos suplementares
Ação
1. JATS XML

Declaração de direitos autorais © Allerton Press, Inc., 2018