Fracture assessment of polymethyl methacrylate using sharp notched disc bend specimens under mixed mode I + III loading
- Авторы: Aliha M.1, Berto F.2,3, Bahmani A.1, Akhondi S.1, Barnoush A.3
-
Учреждения:
- Welding and Joining Research Center, School of Industrial Engineering
- Department of Management and Engineering
- Department of Engineering Design and Materials
- Выпуск: Том 19, № 4 (2016)
- Страницы: 355-364
- Раздел: Article
- URL: https://journals.rcsi.science/1029-9599/article/view/191253
- DOI: https://doi.org/10.1134/S1029959916040020
- ID: 191253
Цитировать
Аннотация
Mixed mode I/III behavior of Perspex (polymethyl methacrylate (PMMA)) is studied experimentally and theoretically in this research using a new and simple laboratory test configuration. The specimen is a circular disc containing a sharp V-notch along the diameter that is loaded by the conventional three-point bend fixture. The critical values of notch stress intensity factors (KIV and KIIIV) were obtained for the whole combinations of modes I and III simply by changing the notch inclination angle relative to the loading rollers. The value of notch fracture toughness under pure or dominantly tension loads was greater than its corresponding value under mode III or dominantly torsion loads. The experimental results were also predicted very well by employing the local strain energy density (SED) criterion.
Ключевые слова
Об авторах
M. Aliha
Welding and Joining Research Center, School of Industrial Engineering
Автор, ответственный за переписку.
Email: m_aliha@yahoo.com
Иран, Narmak, Tehran, 16846-13114
F. Berto
Department of Management and Engineering; Department of Engineering Design and Materials
Email: m_aliha@yahoo.com
Италия, Vicenza, 36100; Trondheim, 7491
A. Bahmani
Welding and Joining Research Center, School of Industrial Engineering
Email: m_aliha@yahoo.com
Иран, Narmak, Tehran, 16846-13114
Sh. Akhondi
Welding and Joining Research Center, School of Industrial Engineering
Email: m_aliha@yahoo.com
Иран, Narmak, Tehran, 16846-13114
A. Barnoush
Department of Engineering Design and Materials
Email: m_aliha@yahoo.com
Норвегия, Trondheim, 7491