Checking of applicability of conditions for reaching the limiting-current mode to flow-by porous electrodes


Дәйексөз келтіру

Толық мәтін

Ашық рұқсат Ашық рұқсат
Рұқсат жабық Рұқсат берілді
Рұқсат жабық Тек жазылушылар үшін

Аннотация

For the flow-by porous electrodes, which differ in thickness, specific surface area, solution flow rate, and a ratio between the phase conductivities, the conditions providing the limiting-current mode over the entire electrode surface at nearly 100% current efficiency are determined using the method of successive refinement of total current and profile of its distribution along the solution flow. The used values of electrode thickness L are compared with available estimates for the limiting thickness of porous electrode Llim derived for the ideal limiting-current mode and calculated using real values of the width of the limiting-current plateau of overall polarization curve, solution conductivity, and the diffusion limiting current in the zone of solution input into the electrode. It is found that these values are close to each other in all cases. The largest error of estimation of Llim does not exceed 10% indicating that it can be used for preliminary estimation of the conditions for reaching the limiting-current mode for the flow porous electrodes of this type.

Авторлар туралы

A. Maslii

Institute of Solid State Chemistry and Mechanochemistry, Siberian Branch

Хат алмасуға жауапты Автор.
Email: masliy@solid.nsc.ru
Ресей, ul. Kutateladze 18, Novosibirsk, 630128

N. Poddubnyi

Institute of Solid State Chemistry and Mechanochemistry, Siberian Branch

Email: masliy@solid.nsc.ru
Ресей, ul. Kutateladze 18, Novosibirsk, 630128

A. Medvedev

Institute of Solid State Chemistry and Mechanochemistry, Siberian Branch

Email: masliy@solid.nsc.ru
Ресей, ul. Kutateladze 18, Novosibirsk, 630128

Қосымша файлдар

Қосымша файлдар
Әрекет
1. JATS XML

© Pleiades Publishing, Ltd., 2017