Calculation of frequency and power characteristics of the composite metal-dielectric resonator using the method of partial regions
- Authors: Savin K.G.1, Golubeva I.P.1, Prokopenko Y.V.1
-
Affiliations:
- National Technical University of Ukraine “Kyiv Polytechnic Institute”
- Issue: Vol 59, No 5 (2016)
- Pages: 229-236
- Section: Article
- URL: https://journals.rcsi.science/0735-2727/article/view/176819
- DOI: https://doi.org/10.3103/S0735272716050058
- ID: 176819
Cite item
Abstract
A new method for calculating the frequency and power characteristics of different modes of a microwave metal-dielectric resonator has been proposed. The results of measurements of experimental specimens are presented that are in good agreement with calculation results. The relationships of the frequency and power characteristics of a resonator as a function of its geometrical and electrophysical parameters were obtained by using the method of partial regions. A high sensitivity of the main mode resonant frequency to the thickness of air inhomogeneity was detected. In this case the introduction of inhomogeneity increases the resonator Q-factor. Thus, the proposed design can be used as a high-Q tunable resonator.
About the authors
K. G. Savin
National Technical University of Ukraine “Kyiv Polytechnic Institute”
Author for correspondence.
Email: savinkg@gmail.com
Ukraine, Kyiv
I. P. Golubeva
National Technical University of Ukraine “Kyiv Polytechnic Institute”
Email: savinkg@gmail.com
Ukraine, Kyiv
Yu. V. Prokopenko
National Technical University of Ukraine “Kyiv Polytechnic Institute”
Email: savinkg@gmail.com
Ukraine, Kyiv