Development of Algorithms and Programs for Construction of Reference Circles for the Analysis of Deviations from Roundness
- 作者: Markov B.N.1, Melikova O.N.1, Ped’ S.E.1
-
隶属关系:
- STANKIN Moscow State Technological University
- 期: 卷 62, 编号 2 (2019)
- 页面: 134-138
- 栏目: Article
- URL: https://journals.rcsi.science/0543-1972/article/view/246681
- DOI: https://doi.org/10.1007/s11018-019-01597-y
- ID: 246681
如何引用文章
详细
A procedure for the construction of reference circles of the profile of the axial section of a test shaft or hole, the maximum inscribed circle and minimum circumscribed circle, along with circles that specify the boundaries of a ring of minimal width, is proposed. The radii and coordinates of the centers of the circles are found through minimization or maximization of a corresponding functional constructed on the basis of the coordinates of the points of the profile. The construction procedures presented are implemented in the Mathcad program package. The results obtained may be used to determine deviations from roundness, in particular, in the development of mathematical software of measuring instruments.
作者简介
B. Markov
STANKIN Moscow State Technological University
编辑信件的主要联系方式.
Email: bnmarkov@rambler.ru
俄罗斯联邦, Moscow
O. Melikova
STANKIN Moscow State Technological University
Email: bnmarkov@rambler.ru
俄罗斯联邦, Moscow
S. Ped’
STANKIN Moscow State Technological University
Email: bnmarkov@rambler.ru
俄罗斯联邦, Moscow
补充文件
