Determination of the Volume of a Tank from the Results of Laser Scanning
- Авторы: Anashkin I.P.1, Mukhamadieva F.F.2, Kondakov A.V.1,2, Migranov V.M.2
-
Учреждения:
- Kazan National Research Technological University
- All-Russia Research Institute of Flow Metering (VNIIR)
- Выпуск: Том 61, № 7 (2018)
- Страницы: 670-674
- Раздел: Linear and Angular Measurements
- URL: https://journals.rcsi.science/0543-1972/article/view/246528
- DOI: https://doi.org/10.1007/s11018-018-1482-6
- ID: 246528
Цитировать
Аннотация
The volume of a tank from the formulations in the State Primary Special Standard of the unit of the volume and mass flow rate of water GET 119–2010 is measured by means of 3D laser scanning. A comparative analysis of reference data and measurement results is presented. The error caused by software processing of the results of scanning is estimated.
Ключевые слова
Об авторах
I. Anashkin
Kazan National Research Technological University
Автор, ответственный за переписку.
Email: anashkin.ivan@gmail.com
Россия, Kazan
F. Mukhamadieva
All-Russia Research Institute of Flow Metering (VNIIR)
Email: anashkin.ivan@gmail.com
Россия, Kazan
A. Kondakov
Kazan National Research Technological University; All-Russia Research Institute of Flow Metering (VNIIR)
Email: anashkin.ivan@gmail.com
Россия, Kazan; Kazan
V. Migranov
All-Russia Research Institute of Flow Metering (VNIIR)
Email: anashkin.ivan@gmail.com
Россия, Kazan
Дополнительные файлы
