Email this article Use of Signals with Power Distributed Over Frequency for Laboratory Calibration of Hydroacoustic Receivers
- Authors: Isaev A.E.1, Chernikov I.V.1
-
Affiliations:
- All-Russia Research Institute of Physicotechnical and Radio Measurements (VNIIFTRI)
- Issue: Vol 58, No 10 (2016)
- Pages: 1174-1178
- Section: Acoustic Measurements
- URL: https://journals.rcsi.science/0543-1972/article/view/245320
- DOI: https://doi.org/10.1007/s11018-015-0861-5
- ID: 245320
Cite item
Open Access
Access granted
Subscription Access
Abstract
It is shown that tone-pulsed, linearly frequency modulated, and noise signals supplement each other harmonically, so that it is important to use them in all levels of a verification scheme. Data from measurement experiments confirm the feasibility of this calibration procedure for acoustic noise emission by the sliding complex weighted average technique.
Keywords
About the authors
A. E. Isaev
All-Russia Research Institute of Physicotechnical and Radio Measurements (VNIIFTRI)
Author for correspondence.
Email: isaev@vniiftri.ru
Russian Federation, Mendeleevo
I. V. Chernikov
All-Russia Research Institute of Physicotechnical and Radio Measurements (VNIIFTRI)
Email: isaev@vniiftri.ru
Russian Federation, Mendeleevo
