卷 80, 编号 3 (2013)

Articles

Review of agricultural tractors deliveries for Russian market

Gorbachiov I., Nefiodov A.

摘要

Issues of imported tractors for rural areas deliveries for Russian market over 2011 year are considered.
Traktory i sel hozmashiny. 2013;80(3):3-4
pages 3-4 views

Parameter optimization of a combined system for the reduction of diesels exhaust gases toxicity

Chernetsov D., Kapustin V.

摘要

Structure, operating principle and results of parameter optimization of a combined system for the reduction of diesels exhaust gases’ toxicity are described.
Traktory i sel hozmashiny. 2013;80(3):5-8
pages 5-8 views

Results of comparative testings of block-module cultivators

Mazitov N., Sharafiyev L., Sakhapov R., Galyautdinov N., Rakhimov R., Chetyrkin Y., Lobachevskiy Y., Dmitriyev S.

摘要

Results of comparative testings of an experimental block-module cultivator and its analogues КПС-4 and Sunflower-5 are given.
Traktory i sel hozmashiny. 2013;80(3):54-56
pages 54-56 views

An improved cultivator’s working organ

Kushnir V., Benyukh O.

摘要

An improved cultivator’s working organ for weeds elimination is described.
Traktory i sel hozmashiny. 2013;80(3):8-9
pages 8-9 views

РСК-2 shrubbery topper

Bychkov V., Shevkun V., Kadykalo G., Kotysko V.

摘要

Construction of a shrubbery topper intended for the regenerative pruning is examined. Its specification and information about laboratory and field tests are given.
Traktory i sel hozmashiny. 2013;80(3):9-11
pages 9-11 views

Benches for laboratory testings of cabbage harvesters

Toncheva N., Tabakova Y., Alatyrev S.

摘要

Construction and principle of operation of benches for laboratory explorations of cabbage harvesters as well as results of their examination are presented.
Traktory i sel hozmashiny. 2013;80(3):11-13
pages 11-13 views

Preconditions of using the sectionally-continuous speed regulation in tractors development

Gorodetskiy K., Shuvayev D., Sheveliov A.

摘要

A method of sectionally-continuous tractor speed variation is examined, based on the rational choice of sufficiently short diapason of diesel compensative parameter. In these conditions power doesn’t decrease below nominal one and fuel economy improves by decrease of diesel rotation rate.
Traktory i sel hozmashiny. 2013;80(3):13-16
pages 13-16 views

Theory of tractor operation in overload mode with enrichment of diesel air charge

Ukhanov A., Ukhanov D., Ryblov M.

摘要

Parameters calculation technique of tractor operating in overload mode with diesel air charge enrichment with various hydrocarbonaceous activators (mineral diesel fuel, А-76, АИ-92 and АИ-95 petrols, ТС-1 kerosene, mixed rape-mineral and safflower-mineral fuels) is produced.
Traktory i sel hozmashiny. 2013;80(3):17-19
pages 17-19 views

A technique of volumetric automated assembly of multispan units

Saninskiy V., Storchak N., Platonova Y.

摘要

Results of investigations in the field of propulsion engineering are given, aiming the obtainment of improved multispan units performance, their operating life, reliability factor, accuracy.
Traktory i sel hozmashiny. 2013;80(3):19-23
pages 19-23 views

Mathematical modeling of leakages in axial-plunger hydraulic machines

Filippova Y., Makarkin I.

摘要

Mathematical modeling of leakages in drainage cavity depending on the degree of depreciation of pumping unit is presented.
Traktory i sel hozmashiny. 2013;80(3):24-25
pages 24-25 views

Simulation testings and modeling of a felling-skidding-processing machine operation in the actual natural conditions

Skrypnik V., Kuznetsov A., Stepanischev O.

摘要

Procedure of simulation testings of a felling-skidding-processing machine in the actual natural conditions is presented and this process is stated.
Traktory i sel hozmashiny. 2013;80(3):26-28
pages 26-28 views

Performance characteristics of an adaptive friction clutch of 2nd generation with separate force-closure

Shishkariov M., Luschik A.

摘要

Load-carrying capacity of an adaptive friction clutch of 2nd generation with separate force-closure is estimated. Relationship between the force of friction clusters closure and the accuracy of operation is revealed.
Traktory i sel hozmashiny. 2013;80(3):28-31
pages 28-31 views

Calculation method of resistance and moment of resistance to soil cutting

Akimov A., Konstantinov Y., Fedorov D.

摘要

Calculation method of resistance and moment of resistance to soil cutting in dependence on rotation angle of working organ is developed. This method can be transferred mainly to other rotation working organs.
Traktory i sel hozmashiny. 2013;80(3):32-35
pages 32-35 views

Calculation of grain mill characteristics for mobile compound feeds aggregates

Klychev Y., Reznik Y., Bestayev L.

摘要

Components of calculation of a two-rolling grain mill as more effective replacement assembly for mobile compound feeds aggregates instead of grain crushers are examined.
Traktory i sel hozmashiny. 2013;80(3):36-37
pages 36-37 views

Probabilistic assessment of indicators of shafts and their joints corrosive fatigue resistance

Chibukhchyan S., Stakyan M.

摘要

Results of fatigue tests of steel 45 samples in the air and in corrosive mediums simulating the atmospheric exposure on shafts and their joints are examined. Functions of corrosion coefficients are suggested and nomograms for the application of these coefficients’ probabilistic values in improved calculations of corrosive fatigue resistance of constructive elements are drawn.
Traktory i sel hozmashiny. 2013;80(3):38-41
pages 38-41 views

Sources of production and professional risks in technical service

Chernoivanov V., Burenko L., Filippova Y., Ivleva I., Kazakova V., Dankov A.

摘要

A block diagram of professional and production risks of diseases and injuries from hazardous and dangerous factors of production on-site is presented. Modern methods and means of protection from principal risks sources are described.
Traktory i sel hozmashiny. 2013;80(3):41-44
pages 41-44 views

A differential method of the hydromechanical transmissions friction clutches diagnostics

Moshkin N., Alekseyev A., Alekseyev V.

摘要

A new method of hydromechanical transmission friction clutches diagnostics is suggested. Results of theoretical research were confirmed experimentally. Algorithm of technical state estimation of hydromechanical transmission friction clutches in bench tests conditions is given.
Traktory i sel hozmashiny. 2013;80(3):44-47
pages 44-47 views

Manual hardening with plasma arc

Korotkov V.

摘要

Effect of surface hardening with plasma arc using the УДГЗ-200 device on properties of different steels was under study. Results of the investigation are given. Prospects of the new technique application are examined.
Traktory i sel hozmashiny. 2013;80(3):47-49
pages 47-49 views

Structural features of Polish tractors

Goltyapin V.

摘要

Tractors manufactured by Polish companies Pronar and Ursus SA, their constructive features and key indicators of technical level are examined.
Traktory i sel hozmashiny. 2013;80(3):50-54
pages 50-54 views

International conference in Belarus State Agrarian Technical University

- -.

摘要

В Белорусском ГАТУ (Агромеханический факультет) 11–12 апреля 2013 г. состоится Международная научно-практическая конференция «Перспективные технологии и технические средства в сельскохозяйственном производстве».
Traktory i sel hozmashiny. 2013;80(3):37
pages 37 views

EXPOCENTRE-2012: figures and facts

- -.

摘要

На встрече руководства ЦВК «Экспоцентр» и ТПП РФ с представителями СМИ, состоявшейся 30 января в Экспоцентре, обсуждались результаты деятельности ЦВК «Экспоцентр», а также новые проекты компании и ее планы на будущее.
Traktory i sel hozmashiny. 2013;80(3):3
pages 3 views


Согласие на обработку персональных данных с помощью сервиса «Яндекс.Метрика»

1. Я (далее – «Пользователь» или «Субъект персональных данных»), осуществляя использование сайта https://journals.rcsi.science/ (далее – «Сайт»), подтверждая свою полную дееспособность даю согласие на обработку персональных данных с использованием средств автоматизации Оператору - федеральному государственному бюджетному учреждению «Российский центр научной информации» (РЦНИ), далее – «Оператор», расположенному по адресу: 119991, г. Москва, Ленинский просп., д.32А, со следующими условиями.

2. Категории обрабатываемых данных: файлы «cookies» (куки-файлы). Файлы «cookie» – это небольшой текстовый файл, который веб-сервер может хранить в браузере Пользователя. Данные файлы веб-сервер загружает на устройство Пользователя при посещении им Сайта. При каждом следующем посещении Пользователем Сайта «cookie» файлы отправляются на Сайт Оператора. Данные файлы позволяют Сайту распознавать устройство Пользователя. Содержимое такого файла может как относиться, так и не относиться к персональным данным, в зависимости от того, содержит ли такой файл персональные данные или содержит обезличенные технические данные.

3. Цель обработки персональных данных: анализ пользовательской активности с помощью сервиса «Яндекс.Метрика».

4. Категории субъектов персональных данных: все Пользователи Сайта, которые дали согласие на обработку файлов «cookie».

5. Способы обработки: сбор, запись, систематизация, накопление, хранение, уточнение (обновление, изменение), извлечение, использование, передача (доступ, предоставление), блокирование, удаление, уничтожение персональных данных.

6. Срок обработки и хранения: до получения от Субъекта персональных данных требования о прекращении обработки/отзыва согласия.

7. Способ отзыва: заявление об отзыве в письменном виде путём его направления на адрес электронной почты Оператора: info@rcsi.science или путем письменного обращения по юридическому адресу: 119991, г. Москва, Ленинский просп., д.32А

8. Субъект персональных данных вправе запретить своему оборудованию прием этих данных или ограничить прием этих данных. При отказе от получения таких данных или при ограничении приема данных некоторые функции Сайта могут работать некорректно. Субъект персональных данных обязуется сам настроить свое оборудование таким способом, чтобы оно обеспечивало адекватный его желаниям режим работы и уровень защиты данных файлов «cookie», Оператор не предоставляет технологических и правовых консультаций на темы подобного характера.

9. Порядок уничтожения персональных данных при достижении цели их обработки или при наступлении иных законных оснований определяется Оператором в соответствии с законодательством Российской Федерации.

10. Я согласен/согласна квалифицировать в качестве своей простой электронной подписи под настоящим Согласием и под Политикой обработки персональных данных выполнение мною следующего действия на сайте: https://journals.rcsi.science/ нажатие мною на интерфейсе с текстом: «Сайт использует сервис «Яндекс.Метрика» (который использует файлы «cookie») на элемент с текстом «Принять и продолжить».