Collapse Characteristics of High-Density Silt Under Principal Stress Rotation

Resumo

To study the collapse characteristics of high-density silt under complex loads, three series of hollow-cylinder tests were conducted on high-density saturated silt samples taken from the sea entrance of the Yangtze River. In the first series of tests, samples with high density were isotropically consolidated and then sheared under undrained triaxial loads. In subsequent tests, samples with low and high densities were isotropically consolidated and then cyclically sheared by principal stress rotation of 0-180°. Collapse and liquefaction were clearly observed in all the samples tested under cyclic principal stress rotation when the pore water pressure was equal to the initial effective confining pressure. Two critical points, the graded phase transformation point and the cataclysmic phase transformation point (collapse point), were observed for the high-density samples before liquefaction; these divided the buildup of the pore water pressure into three or two stages depending the shear stress level. At low shear stresses, the characteristics of the transformation points were hardly influenced by load frequency. The isotropic consolidated high-density silt and low-density silt expressed similar behaviors. However, in the high-density silt, the strain development could be divided into two stages by the collapse point, which corresponds to the cataclysmic phase transformation point of the pore water pressure representing the state of structure collapse. The deviator strains were limited within a narrow range of 0.2-0.4% at the collapse state. The stress state of collapse can be normalized by the quasi-unstable line in the p'-q space. Finally, we introduce the modified Seed model to successfully estimate the development of pore water pressure in high-density silt.