Selection of the Optimum Electrolysis Bath Composition for the Synthesis of Holmium–Iron Triad Metal Intermetallics

Resumo

The results of high-temperature electrochemical synthesis of holmium–iron triad metal intermetallics in chloride melts are presented. The influence of the current density, the composition of an electrolysis bath, and the synthesis time on the electrolysis processes and the composition of the end product is studied. The electrolysis of the molten KCl–NaCl mixture containing 0.5–2.5 mol % holmium trichloride and 0.1–2.5 mol % nickel (cobalt) dichloride at a current density of 0.5–2.0 A/cm², a temperature of 973–1073 K, and an electrolysis time of 30–90 min is shown to cause the formation of a cathode deposit in the form of a “metal–salt pear” on a tungsten electrode. This pear consists of a mixture of metallic nickel (cobalt) and HoNi, HoNi₅, and HoNi₃ (HoCo₂, HoCo₃, HoCo₅, Ho₂Co₁₇) intermetallics. The intermetallic compound content in the cathode deposit is found to increase at a constant current density (1.2 A/cm²) and when the holmium chloride content in a melt or the ratio of the holmium chloride concentration to the nickel (cobalt) chloride concentration increases. Only a mixture of holmium–nickel (cobalt) intermetallics can exist in the cathode deposit if the electrolysis bath composition and the electrolysis parameters are controlled. The electrochemical synthesis of holmium–iron intermetallics was performed under galvanostatic conditions in molten KCl–NaCl–HoCl₃. Iron ions are introduced in a melt via the anodic dissolution of metallic iron. The results of X-ray diffraction analysis of the electrolysis products demonstrate the fundamental possibility of synthesizing holmium–iron intermetallics. The optimum conditions of electrosynthesis of holmium–iron triad metal intermetallics are determined.