Мақаланы E-mail арқылы жіберу Adhesion Strength of Ceramic Coatings to Dental Ni–Cr Alloy Fabricated by Casting with 3D Printed Patterns
- Авторлар: Dikova T.1, Dolgov N.2, Vasilev T.3, Katreva I.1
-
Мекемелер:
- Medical University of Varna
- Pisarenko Institute for Problems of Strength, National Academy of Sciences of Ukraine
- Nikola Vaptsarov Naval Academy
- Шығарылым: Том 2019, № 4 (2019)
- Беттер: 385-391
- Бөлім: Advanced Materials and Technologies
- URL: https://journals.rcsi.science/0036-0295/article/view/173174
- DOI: https://doi.org/10.1134/S0036029519040086
- ID: 173174
Дәйексөз келтіру
Ашық рұқсат
Рұқсат берілді
Тек жазылушылар үшін
Аннотация
The adhesion of IPS InLine ceramics to a cast dental Ni–Cr (Wiron light) alloy is experimentally studied during the tensile test of flat coated specimens, and the results of a numerical simulation and multicriteria optimization using the MADMML software package are presented. Casting patterns were printed on a 3D Rapidshape printer at angles of 0° and 90° by a layer 35 and 50 μm thick. The adhesion strength of the coating is 77.9–79.9 MPa under optimum conditions.
Авторлар туралы
Ts. Dikova
Medical University of Varna
Хат алмасуға жауапты Автор.
Email: tsanka_dikova@abv.bg
Болгария, Varna
N. Dolgov
Pisarenko Institute for Problems of Strength, National Academy of Sciences of Ukraine
Email: tsanka_dikova@abv.bg
Украина, Kiev
T. Vasilev
Nikola Vaptsarov Naval Academy
Email: tsanka_dikova@abv.bg
Болгария, Varna
I. Katreva
Medical University of Varna
Email: tsanka_dikova@abv.bg
Болгария, Varna
