Email this article Estimation of plastic deformation in the technologies of bulk cold deformation
- Authors: Gliner R.E.1, Katyukhin E.B.1, Zhalilov D.R.1, Vybornov V.V.2, Pryanichnikov V.A.3
-
Affiliations:
- Nizhni Novgorod State Technical University
- OOO Bulen Rus
- OOO VolgoStal’Proekt
- Issue: Vol 2016, No 13 (2016)
- Pages: 1298-1302
- Section: Metal Forming
- URL: https://journals.rcsi.science/0036-0295/article/view/171164
- DOI: https://doi.org/10.1134/S0036029516130061
- ID: 171164
Cite item
Open Access
Access granted
Subscription Access
Abstract
A technique for determining the degree of reduction upon forming by cold bulk shaping has been proposed. The technique is based on a comparison of the measurement data on the hardness of a cold-worked metal with that of the same metal subjected to a compression test at a certain strain intensity. The technique has been tested in technological operations of reduction and thread rolling.
About the authors
R. E. Gliner
Nizhni Novgorod State Technical University
Author for correspondence.
Email: gleen1@yandex.ru
Russian Federation, ul. Minina 24, Nizhny Novgorod, 603155
E. B. Katyukhin
Nizhni Novgorod State Technical University
Email: gleen1@yandex.ru
Russian Federation, ul. Minina 24, Nizhny Novgorod, 603155
D. R. Zhalilov
Nizhni Novgorod State Technical University
Email: gleen1@yandex.ru
Russian Federation, ul. Minina 24, Nizhny Novgorod, 603155
V. V. Vybornov
OOO Bulen Rus
Email: gleen1@yandex.ru
Russian Federation, pr. Lenina 88, Nizhny Novgorod, 603004
V. A. Pryanichnikov
OOO VolgoStal’Proekt
Email: gleen1@yandex.ru
Russian Federation, ul. Chaadaeva 1, Nizhny Novgorod, 603035
