New Radiation Input/Output Systems for Millimeter-Wave Gyrotron Traveling-Wave Tubes
- Autores: Denisov G.G.1,2, Bogdashov A.A.1, Gachev I.G.1, Mishakin S.V.1, Samsonov S.V.1
-
Afiliações:
- Institute of Applied Physics of the Russian Academy of Sciences
- N. I. Lobachevsky State University of Nizhny Novgorod
- Edição: Volume 58, Nº 10 (2016)
- Páginas: 769-776
- Seção: Article
- URL: https://journals.rcsi.science/0033-8443/article/view/243640
- DOI: https://doi.org/10.1007/s11141-016-9649-y
- ID: 243640
Citar
Resumo
We consider in detail the method allowing one to input and output the microwave radiation produced by an elecrovacuum amplifier through the same barrier window, which was proposed earlier, in the context of its application in a traveling-wave tube based on a waveguide with a helically corrugated surface. Special attention is given to the splitter of differently polarized radiation, and the results of studying this splitter at wavelengths of about 6 and 1 mm theoretically and experimentally are presented.
Palavras-chave
Sobre autores
G. Denisov
Institute of Applied Physics of the Russian Academy of Sciences; N. I. Lobachevsky State University of Nizhny Novgorod
Email: samsonov@appl.sci-nnov.ru
Rússia, Nizhny Novgorod; Nizhny Novgorod
A. Bogdashov
Institute of Applied Physics of the Russian Academy of Sciences
Email: samsonov@appl.sci-nnov.ru
Rússia, Nizhny Novgorod
I. Gachev
Institute of Applied Physics of the Russian Academy of Sciences
Email: samsonov@appl.sci-nnov.ru
Rússia, Nizhny Novgorod
S. Mishakin
Institute of Applied Physics of the Russian Academy of Sciences
Email: samsonov@appl.sci-nnov.ru
Rússia, Nizhny Novgorod
S. Samsonov
Institute of Applied Physics of the Russian Academy of Sciences
Autor responsável pela correspondência
Email: samsonov@appl.sci-nnov.ru
Rússia, Nizhny Novgorod
Arquivos suplementares
