Alternative Technology for Manufacturing Rod–Wire Products from AK12 Silumin
- Authors: Zagirov N.N.1, Loginov Y.N.2, Sidel’nikov S.B.1, Ivanov E.V.1
-
Affiliations:
- Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”
- Federal State Autonomous Educational Institution of Higher Education “El’tsin Ural Federal University”
- Issue: Vol 62, No 5-6 (2018)
- Pages: 587-596
- Section: Article
- URL: https://journals.rcsi.science/0026-0894/article/view/241994
- DOI: https://doi.org/10.1007/s11015-018-0696-9
- ID: 241994
Cite item
Abstract
We develop and test a flow diagram of the process of manufacturing of rods and wires from graded loose chip wastes of eutectic silumin based on the use solely of the procedures of plastic working and heat treatment. In its realization, we use the method of combined rolling–pressing of preliminarily briquetted chips with subsequent drawing of pressed rods. The possibility of getting semifinished and finished products with higher levels of strength and plastic properties as compared with cast silumin is demonstrated. The specific features of formation of the structure of the material after the realization of individual stages of the general flow diagram are indicated.
About the authors
N. N. Zagirov
Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”
Author for correspondence.
Email: kafomd_1@mail.ru
Russian Federation, Krasnoyarsk
Yu. N. Loginov
Federal State Autonomous Educational Institution of Higher Education “El’tsin Ural Federal University”
Email: kafomd_1@mail.ru
Russian Federation, Ekaterinburg
S. B. Sidel’nikov
Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”
Email: kafomd_1@mail.ru
Russian Federation, Krasnoyarsk
E. V. Ivanov
Federal State Autonomous Educational Institution of Higher Education “Siberian Federal University”
Email: kafomd_1@mail.ru
Russian Federation, Krasnoyarsk
Supplementary files
