Technological thermal stresses in the shrink fitting of cylindrical bodies with consideration of plastic flows
- Authors: Dats E.P.1, Tkacheva A.V.2
-
Affiliations:
- Vladivostok State University of Economics and Service
- Institute of Engineering and Metallurgy, Far East Branch
- Issue: Vol 57, No 3 (2016)
- Pages: 569-576
- Section: Article
- URL: https://journals.rcsi.science/0021-8944/article/view/159467
- DOI: https://doi.org/10.1134/S0021894416030214
- ID: 159467
Cite item
Abstract
This paper presents a solution of a sequence of one-dimensional boundary-value problems of thermal stresses defining the elastic–plastic deformation processes used in the shrink fitting of cylindrical bodies. The initiation and development of plastic flow in the materials of the assembly elements are studied taking into account the temperature dependence of the yield stress of these materials. During temperature equalization, the flow can slow down, followed by unloading and formation of a residual stress field providing tension. The conditions of formation and motion of the boundaries of the elastic and plastic states in plastic flow and during unloading are determined.
Keywords
About the authors
E. P. Dats
Vladivostok State University of Economics and Service
Author for correspondence.
Email: dats@dvo.ru
Russian Federation, Vladivostok, 690990
A. V. Tkacheva
Institute of Engineering and Metallurgy, Far East Branch
Email: dats@dvo.ru
Russian Federation, Komsomolsk-on-Amur, 681005