Email this article Plate Manufacturing Technology for a Sectional Tool Made of Tungsten-Cobalt Hard Alloy
- Authors: Reva V.P.1, Mansurov Y.N.1, Kuryavyi V.G.2, Petrov V.V.3, Kim V.A.3
-
Affiliations:
- Far East Federal University
- Institute of Chemistry, Far East Branch of the Russian Academy of Sciences
- Komsomolsk-on-Amur State Technical University
- Issue: Vol 52, No 1-2 (2016)
- Pages: 59-62
- Section: Manufacturing Technology
- URL: https://journals.rcsi.science/0009-2355/article/view/234462
- DOI: https://doi.org/10.1007/s10556-016-0148-y
- ID: 234462
Cite item
Open Access
Access granted
Subscription Access
Abstract
Production aspects are provided for manufacturing sintered tungsten-cobalt alloy VK8 based on tungsten carbide prepared by mechanochemical synthesis. It is shown that experimental alloy VK8 physicomechanical, and operating properties significantly exceed those of commercial grade hard alloy, which opens up possibilities for its use in preparing cutting, drilling, and also stamping tools operating under dynamic conditions.
About the authors
V. P. Reva
Far East Federal University
Author for correspondence.
Email: festurvp@mail.ru
Russian Federation, Vladivostok
Yu. N. Mansurov
Far East Federal University
Email: festurvp@mail.ru
Russian Federation, Vladivostok
V. G. Kuryavyi
Institute of Chemistry, Far East Branch of the Russian Academy of Sciences
Email: festurvp@mail.ru
Russian Federation, Vladivostok
V. V. Petrov
Komsomolsk-on-Amur State Technical University
Email: festurvp@mail.ru
Russian Federation, Komsomolsk-on-Amur
V. A. Kim
Komsomolsk-on-Amur State Technical University
Email: festurvp@mail.ru
Russian Federation, Komsomolsk-on-Amur
Supplementary files
