Creating Sealing Surface of Shutoff Assembly of Pipeline Fittings
- Authors: Zaides S.A.1, Gaisin S.N.1
-
Affiliations:
- Irkutsk National Research Technical University
- Issue: Vol 53, No 1-2 (2017)
- Pages: 106-110
- Section: Article
- URL: https://journals.rcsi.science/0009-2355/article/view/235395
- DOI: https://doi.org/10.1007/s10556-017-0303-0
- ID: 235395
Cite item
Abstract
The leak-tightness of shutoff assembly of pipeline fittings is analyzed. It is shown that leak-tightness of shutoff assemblies depends on the presence of a continuous line formed by the contact spots rather than the area of the contact surfaces. A kinematic scheme and a design of a multi-disk grinding device that ensure high quality of sealing surfaces are presented. The results of experimental research, which confirm the quality of finishing of sealing surfaces of the shutoff assembly, are reported.
About the authors
S. A. Zaides
Irkutsk National Research Technical University
Author for correspondence.
Email: zsa@istu.edu
Russian Federation, Irkutsk
S. N. Gaisin
Irkutsk National Research Technical University
Email: zsa@istu.edu
Russian Federation, Irkutsk