Analysis of Operating Conditions of Sliding Friction Units of Driving System of High-Pressure Oil and Gas Well Service Plunger Pumps
- Authors: Kireev S.O.1, Nikishenko S.L.1, Vasil’ev B.N.2, Vasil’ev M.A.2
-
Affiliations:
- Don State Technical University
- South-Russia State Polytechnic University
- Issue: Vol 52, No 5-6 (2016)
- Pages: 332-338
- Section: Article
- URL: https://journals.rcsi.science/0009-2355/article/view/234759
- DOI: https://doi.org/10.1007/s10556-016-0195-4
- ID: 234759
Cite item
Abstract
The characteristic parameters for evaluating the efficiency of working surfaces of sliding friction units and calculating their operating conditions are the speed of movement of the mated surfaces relative to each other and the loads on them. To determine them by analytical methods, kinematic and force studies of the crank mechanism of the driving system were carried out with reference to a chosen typical representative of this group of pumps. The proposed method can be used to obtain initial approximate data that are adequate for further structural analysis and designing of these friction units.
Keywords
About the authors
S. O. Kireev
Don State Technical University
Author for correspondence.
Email: kireevso@yandex.ru
Russian Federation, Rostov-on-Don
S. L. Nikishenko
Don State Technical University
Email: kireevso@yandex.ru
Russian Federation, Rostov-on-Don
B. N. Vasil’ev
South-Russia State Polytechnic University
Email: kireevso@yandex.ru
Russian Federation, Novocherkassk
M. A. Vasil’ev
South-Russia State Polytechnic University
Email: kireevso@yandex.ru
Russian Federation, Novocherkassk