Turning of F-4UV20 Composite Plastic

T. R. Ablyaz; E. V. Matygullina; L. D. Sirotenko; D. I. Tokarev; A. A. Drozdov

doi:10.3103/S1068798X19100034

Turning of F-4UV20 Composite Plastic

Autores: Ablyaz T.R.¹, Matygullina E.V.¹, Sirotenko L.D.¹, Tokarev D.I.¹, Drozdov A.A.¹
Afiliações:
1. Perm National Research Polytechnic University
Edição: Volume 39, Nº 10 (2019)
Páginas: 884-885
Seção: Article
URL: https://journals.rcsi.science/1068-798X/article/view/227845
DOI: https://doi.org/10.3103/S1068798X19100034
ID: 227845

Citar

Texto integral

Acesso aberto
Acesso é fechado

Acesso está concedido
Acesso é fechado

Somente assinantes

Resumo
Sobre autores
Bibliografia
Arquivos suplementares
Estatísticas

Resumo

The turning of F-4UV20 composite plastic is investigated. Continuous chip is formed in all the experimental conditions: cutting speed 16–100 m/min; supply 0.05–0.2 mm/turn; cutting depth 0.5–2 mm. The wear of the cutting insert is uniform (0.1 mm at the rear surface and 0.3 mm at the front surface), with no traces of adhesion. After turning, carbon fibers remain on the machined surface, conferring antifrictional properties without significant effect on the roughness.