Email this article Programmable end milling of thermoplastics
- Authors: Emel’yanenko A.A.1, Zhabin O.I.1, Polyanchikov Y.N.2
-
Affiliations:
- AO NII Gidrosvyazi Shtil’
- Volgograd State Technical University
- Issue: Vol 37, No 2 (2017)
- Pages: 122-124
- Section: Article
- URL: https://journals.rcsi.science/1068-798X/article/view/227233
- DOI: https://doi.org/10.3103/S1068798X1702006X
- ID: 227233
Cite item
Open Access
Access granted
Subscription Access
Abstract
The end milling of industrial and engineering thermoplastics on numerically controlled machine tools is considered. Specifically, attention focuses on the sources and prevention of machining defects. Recommendations are made regarding the selection of the tool geometry, the cutting conditions, and the mill trajectory.
About the authors
A. A. Emel’yanenko
AO NII Gidrosvyazi Shtil’
Author for correspondence.
Email: emelyanenko_aleksei@mail.ru
Russian Federation, Volgograd
O. I. Zhabin
AO NII Gidrosvyazi Shtil’
Email: emelyanenko_aleksei@mail.ru
Russian Federation, Volgograd
Yu. N. Polyanchikov
Volgograd State Technical University
Email: emelyanenko_aleksei@mail.ru
Russian Federation, Volgograd
Supplementary files
