Application of Orthogonal Central Composition Planning of Experiments to Optimize the Turning of KhVG-Hardened Steel by Cutting Ceramics
- Autores: Pronin A.I.1, Mylnikov V.V.2, Romanov A.D.3
-
Afiliações:
- Komsomolsk-na-Amure State Technical University
- Nizhny Novgorod State University of Architecture and Civil Engineering
- Nizhny Novgorod State Technical University
- Edição: Volume 47, Nº 1 (2018)
- Páginas: 112-120
- Seção: Experimental Mechanics, Diagnostics, and Testing
- URL: https://journals.rcsi.science/1052-6188/article/view/193783
- DOI: https://doi.org/10.3103/S1052618818010132
- ID: 193783
Citar
Resumo
A solution of the problem of optimization of the technological process of turning KhVGhardened steel (HRC 55) is presented. The radial component of cutting forces during the machining of hardened steel by cutting ceramics is accepted as the optimization parameter. The influence of two factors, the cutting rate and feed per revolution, were examined. An orthogonal central composition plan was used to solve this problem. The empirical dependence of the radial component of the cutting force on the cutting rate and feed per revolution is presented. The character of the influence of each factor on the parameter optimization is determined. The optimal values of factors corresponding to the minimum value of the radial component of the cutting force were finally determined.
Sobre autores
A. Pronin
Komsomolsk-na-Amure State Technical University
Autor responsável pela correspondência
Email: mrmylnikov@mail.ru
Rússia, Komsomolsk-on-Amur, 681013
V. Mylnikov
Nizhny Novgorod State University of Architecture and Civil Engineering
Email: mrmylnikov@mail.ru
Rússia, Nizhny Novgorod, 603950
A. Romanov
Nizhny Novgorod State Technical University
Email: mrmylnikov@mail.ru
Rússia, Nizhny Novgorod, 603950
Arquivos suplementares
