Email this article Shaping of sheet to produce large-diameter welded pipe
- Authors: Zvonarev D.Y.1, Osadchii V.Y.2, Romantsov A.I.3, Kolikov A.P.4
-
Affiliations:
- OAO RosNITI
- Moscow State Technical University
- OAO ChTPZ
- National University of Science and Technology “MISiS”
- Issue: Vol 46, No 6 (2016)
- Pages: 443-446
- Section: Article
- URL: https://journals.rcsi.science/0967-0912/article/view/178806
- DOI: https://doi.org/10.3103/S0967091216060140
- ID: 178806
Cite item
Open Access
Access granted
Subscription Access
Abstract
The quality of welded pipe (diameter 508–1420 mm; wall thickness 8–48 mm) of strength class up to K80 (X100) is investigated. Plastic shaping is simulated, with quantitative estimation of the stress–strain state of thick-walled pipe blanks in TESA 1420 presses during edge bending and stepwise shaping. The corresponding computer program permits calculation of the setup of the equipment and determination of the geometric parameters of the pipe blank specified in the standards. Theoretical results are presented for a range of large-diameter pipe produced on the TESA 1420 system.
About the authors
D. Yu. Zvonarev
OAO RosNITI
Email: apkolikov@mail.ru
Russian Federation, Chelyabinsk
V. Ya. Osadchii
Moscow State Technical University
Email: apkolikov@mail.ru
Russian Federation, Moscow
A. I. Romantsov
OAO ChTPZ
Email: apkolikov@mail.ru
Russian Federation, Chelyabinsk
A. P. Kolikov
National University of Science and Technology “MISiS”
Author for correspondence.
Email: apkolikov@mail.ru
Russian Federation, Moscow
Supplementary files
