Strength of freight bogie solebar fragments after volume–surface quenching
- Autores: Nikulin S.1, Oguenko V.2, Rozhnov A.1, Turilina V.1, Nechaikina T.1, Rogachev S.1
-
Afiliações:
- National University of Science and Technology MISiS
- Research and Engineering–Technological Institute of Rolling Stock (VNIIKTI)
- Edição: Volume 2016, Nº 10 (2016)
- Páginas: 986-991
- Seção: Applied Problems of Strength and Plasticity
- URL: https://journals.rcsi.science/0036-0295/article/view/170959
- DOI: https://doi.org/10.1134/S0036029516100153
- ID: 170959
Citar
Resumo
The structure and mechanical properties of fragments from freight bogie solebars made of 20GL steel are determined in the initial normalized state and after thermal hardening by volume–surface quenching. This quenching is shown to increase the strength of a solebar fragment with a wall thickness of at most 20 mm almost twofold as compared to the normalized state and to increase its bearing capacity by a factor of approximately 1.5.
Palavras-chave
Sobre autores
S. Nikulin
National University of Science and Technology MISiS
Autor responsável pela correspondência
Email: nikulin@misis.ru
Rússia, Leninskii pr. 4, Moscow, 119049
V. Oguenko
Research and Engineering–Technological Institute of Rolling Stock (VNIIKTI)
Email: nikulin@misis.ru
Rússia, Kolomna, 140402
A. Rozhnov
National University of Science and Technology MISiS
Email: nikulin@misis.ru
Rússia, Leninskii pr. 4, Moscow, 119049
V. Turilina
National University of Science and Technology MISiS
Email: nikulin@misis.ru
Rússia, Leninskii pr. 4, Moscow, 119049
T. Nechaikina
National University of Science and Technology MISiS
Email: nikulin@misis.ru
Rússia, Leninskii pr. 4, Moscow, 119049
S. Rogachev
National University of Science and Technology MISiS
Email: nikulin@misis.ru
Rússia, Leninskii pr. 4, Moscow, 119049