Microstructure and Adhesion Strength of Ni3Ti Coating Prepared by Mechanical Alloying and HVOF

Аннотация

In the present work we report the development of Ni₃Ti intermetallic compound by high energy ball milling of Ni and Ti powders. The ball milled powders were taken at various intervals (4, 6, 8, 10, and 11 h) to analyze the formation of Ni_xTi_x intermetallic compounds. The ball milled powders were analyzed using scanning electron microscopy and X-ray diffraction. The layered shaped powder particles of Ni₃Ti phase were formed after 11 h of ball milling, which was confirmed by X-ray peaks. Further High-Velocity Oxy-Fuel (HVOF) process was used to coat Ni₃Ti and Ni₃Ti + (Cr₃C₂ + 20NiCr) on MDN 420 steel. Both the coated materials displayed excellent cohesion with minimal porosity less than 2%. The tensile adhesion strength test was carried out on these coatings to check the bond strength. Out of the two the Ni₃Ti coating showed excellent bond strength of 41.04 MPa compared to that of Ni₃Ti + (Cr₃C₂ + 20NiCr) coating.