Reinforcing the Holes in High-Pressure Vessels
- Autores: Pimshtein P.1, Barabanova L.1
-
Afiliações:
- Irkutsk Research and Design Institute of Chemical and Petrochemical Engineering (IrkutskNIIkhimmash)
- Edição: Volume 54, Nº 1-2 (2018)
- Páginas: 87-93
- Seção: Article
- URL: https://journals.rcsi.science/0009-2355/article/view/236167
- DOI: https://doi.org/10.1007/s10556-018-0444-9
- ID: 236167
Citar
Resumo
Optimization of the design of reinforcements of holes is achieved through an analysis of conditions for reinforcing holes in pressure vessels adopted in contemporary regulatory documents. A calculation of their stress-strain state performed by the Nastran program is used as an example. For entries into elliptical floors, a decrease in the estimated length of the reinforcing metal is recommended. It is shown that effective reinforcement of the lateral entries into a cylinder is possible only by increasing the total wall thickness of the body at the site of the entry.
Palavras-chave
Sobre autores
P. Pimshtein
Irkutsk Research and Design Institute of Chemical and Petrochemical Engineering (IrkutskNIIkhimmash)
Autor responsável pela correspondência
Email: pim1937@mail.ru
Rússia, Irkutsk
L. Barabanova
Irkutsk Research and Design Institute of Chemical and Petrochemical Engineering (IrkutskNIIkhimmash)
Email: pim1937@mail.ru
Rússia, Irkutsk